The unit will automatically enter standby mode when finished.
When the IR LED starts blinking, release the V+ button. The process takes roughly 3–4 minutes.
💡 For direct "dump" files (2MB), you will need a hardware programmer like the RT809F to write the data directly to the SPI flash chip on the board.
is hosted on Software Zone . This version is typically for USB recovery. 🛠️ Hardware Specifications
The unit will automatically enter standby mode when finished.
When the IR LED starts blinking, release the V+ button. The process takes roughly 3–4 minutes.
💡 For direct "dump" files (2MB), you will need a hardware programmer like the RT809F to write the data directly to the SPI flash chip on the board.
is hosted on Software Zone . This version is typically for USB recovery. 🛠️ Hardware Specifications
