How To | Setup And Use A Laser Cutter With Rd Works

In the setup window, select your language and preferred unit of measurement (mm or inches). 2. Connecting the Machine

Run the installation file and select "Install".

You can connect your computer to the laser cutter via USB or Ethernet. How to setup and use a laser cutter with RD Works

In RDWorks, go to the bottom right settings panel and click "Test." If it says "Port test success," you are ready. 3. Basic Operations in RDWorks

Use the cable provided and plug it into the port labeled "PC" on the machine (avoid using the port for USB flash drives). In the setup window, select your language and

For a more stable connection over long distances, you can configure a static IP address on both your PC and the machine.

Once the software is installed, a menu typically appears to install the USB driver. This step is crucial for your computer to recognize the laser cutter. You can connect your computer to the laser

Before connecting your hardware, you must install the software and its drivers correctly.