Installing sliding "coupe" doors (whether for a wardrobe or as an interior room divider) is a manageable DIY project that focuses on precise measurements and level tracks. 1. Preparatory Measurements Before installation, verify your opening dimensions.
: This is usually the first piece installed. Cut it to the width of the opening using a hacksaw. Secure it to the top jamb or ceiling header using screws, ensuring it is perfectly level. Lower Track : instruktsiia po ustanovki dveri kupe
Lift the (the one further inside the closet) first. Installing sliding "coupe" doors (whether for a wardrobe
: If your kit includes stoppers or soft-close mechanisms, slide them into the top track and tighten them at the points where the doors should stop. Recommended Tools Level and tape measure Drill with pilot bits Hacksaw (to trim tracks) Screwdriver (for adjustment screws) Installing a Sliding Closet Door Track : This is usually the first piece installed
: Turning these screws clockwise or counter-clockwise will raise or lower that side of the door to make it plumb.
For , align the lower track with the top one using a level or plumb line.
: Typically, the combined door panels should be at least 10 cm wider than the opening to provide a sufficient overlap when closed. 2. Installing the Tracks
