Speed Searchв Control V 15.0.2 [ High Speed ]

Look for a steady LED indicator or a software status bit that confirms the drive is in "Speed Search" mode during startup.

Decide if you want it to trigger automatically after a power loss or every time a "Run" command is given. 2. Configure Current and Timing Speed searchВ Control v 15.0.2

Set b3-01 (Speed Search Selection) to 1 (Enabled) . Look for a steady LED indicator or a

In the context of industrial automation and , "Speed Search" (often called "Catch-on-the-Fly") is a feature that allows a drive to restart into a motor that is already spinning (e.g., after a brief power loss or while a fan is windmilling). Configure Current and Timing Set b3-01 (Speed Search

Ensure your control method (e.g., V/f Control or Open Loop Vector) supports Speed Search, as some high-precision flux vector modes require specific PG feedback tuning to work.

Set the time the drive takes to "search" down from the maximum frequency. A default of 2.0 seconds is common. 3. Verification & Safety

If you are using a specific software suite (like or Alta Control ) where "v 15.0.2" refers to a firmware version, check the Cisco Bug Search Tool or the Alta Release Notes to see if "Speed Search" refers to a new UI search optimization or performance feature.